MAIN PAGE > PRODUCTS > HT-400 > SAFETY DATA SHEET | BACK ONE |
SECTION I Identification Manufacturer: Hydrochemical Techniques Inc P.O.Box 2078 Hartford, Connecticut 06145 Product Name: Hydroclean HT-400 Super Concentrate Excess Mortar Remover Emergency Telephone Number: (800) 278-7681 Date Prepared: January 10, 2019 |
SECTION II Hazard(s) Identification UN 1789 Hydrochloric acid, Corrosive, 8, PG II Chemical Name: Hydrochloric Acid (Muriatic Acid) - CAS Number 7647-01-1 - % 36.0-40.0 - TLV (UNITS) 5 PPM |
SECTION III Composition/Information on Ingredients HT-400 is a blend of various acids and wetting agents. This product is completely biodegradeable. |
SECTION IV First-Aid Measures Threshold Limit Value: 25PPM Effects of Overexposure: Extreme exposure may cause irritation of eyes and respiratory passage. Liquid contact with eyes can cause burns. Skin contact can cause irritation. Emergency & First Aid Procedures: Inhalation - Move victim to fresh air. Skin - Flush with water for 15 minutes. Eyes - Flush eyes for 15 minutes with water, then use mild eye rinse containing Sodium Bicarbonate. Seek prompt medical attention. |
SECTION V Fire Fighting Measures N/A: HT-400 is a non-flammable, water-based product. |
SECTION VI Accidental Release Measures Spills or Leaks: Contain spilled areas with dikes, etc. Neutralize with soda ash and wash down area with plenty of water. Product is completely biodegradable. Waste Disposal: Neutralize with soda ash or lime. Flush residue in accordance with all State and Federal regulations. Product is completely biodegradable. |
SECTION VII Handling and Storage Handling & Storage: Store in a cool place and handle with protective equipment. Never add acid or anything other than water to this product. Other Precautions: Keep quick drench facilities on job site and eyewash solution containing Sodium Bicarbonate. |
SECTION VIII Exposure Controls/Personal Protection Boiling Point (°F): 230° Vapor Pressure (mm Hg): 29.90 Vapor Density (Air = 1): Not Available Solubility In Water (20°C): 100% Appearance & Odor: Clear Liquid, Acidic Odor Identifiaction Number: UN 1789 Specific Gravity: 1.16 PERCENT, VOLATILE / VOLUME: 31 Evaporation Rate: Not Available pH: .6 in Concentrate Respiratory: If concentrations should exceed 25PPM, use NIOSH/MSHA approved full face respirator. Ventilation: Provide proper ventilation to keep exposure below the threshold limit value (25 PPM). Gloves: Wear acid resistant gloves. Rubber, neoprene or PVC Eye: Wear full face plastic face shield or goggles. Other Protective Equipment: Hard hat, acid resistant jacket, trousers and boots. |
SECTION IX Physical and Chemical Properties This is an acidic liquid in concentrate that has been formulated to specifically for the removal of heavy build-ups of mortar smears and construction dirt from masonry. |
SECTION X Stability and Reactivity Stability: Stable Incompatability (Materials to Avoid): Do not mix with other products. Hazardous Decomposition Products: Not Available Conditions to Avoid: Contact with strong alkaline solutions or unknown solutions. Handling & Storage: Store in a cool place and handle with protective equipment. Never add acid or anything other than water to this product. Other Precautions: Keep quick drench facilities on job site and eyewash solution containing Sodium Bicarbonate. |
MAIN PAGE > PRODUCTS > HT-400 > SAFETY DATA SHEET : TOP |
http://www.hydroclean.com All information and photos are copyright Hydroclean. No material may be reproduced without express written permission from Hydrochemcial Techniques, Inc. HYDROCLEAN Hydrochemical Techniques, Inc. PO Box 2078 Hartford, CT 06145 Tel: 800-278-7681 860-527-6350 Fax: 860-527-4067 info@hydroclean.com |